Nissan Juke Service and Repair Manual : Key reminder function does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM

Check that DTC is not detected with BCM.

Is the inspection result normal? YES >> GO TO 2.

NO >> Refer to BCS-67, "DTC Index".

2.CHECK “ANTI KEY LOCK IN FUNCTI” SETTING IN “WORK SUPPORT”

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.

2. Select “ANTI KEY LOCK IN FUNCTI” in “WORK SUPPORT” mode.

3. Check “ANTI KEY LOCK IN FUNCTI” in “WORK SUPPORT”.

Refer to DLK-219, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (Without Super Lock)".

Is the inspection result normal? YES >> GO TO 3.

NO >> Set “ANTI KEY LOCK IN FUNCTI” in “WORK SUPPORT”.

3.CHECK DOOR SWITCH

Check door switch.

Refer to DLK-258, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK INSIDE KEY ANTENNA

Check inside key antenna.

• Instrument center: Refer to DLK-230, "DTC Logic".

• Console: Refer to DLK-232, "DTC Logic".

• Luggage room: Refer to DLK-234, "DTC Logic".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.CHECK UNLOCK SENSOR

Check unlock sensor.

Refer to DLK-270, "Component Function Check".

Is the inspection result normal? YES >> GO TO 6.

NO >> Repair or replace the malfunctioning parts.

6.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Hazard and buzzer reminder does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Off position warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Other materials:

    Cockpit
    1. Outside mirror remote control switch 2. Headlight, fog light and turn signal switch — Headlight — Turn signal light — Fog light 3. Steering wheel — Electric power steering system — Horn — Driver’s supplemental air bag 4. Wiper and washer switch 5. Shift lever — Continuously V ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

    Rear wiper arm
    Exploded View 1. Rear wiper motor 2. Rear wiper blade 3. Rear wiper arm 4. Rear wiper arm cover 5. Rear wiper pivot seal A : Model for cold areas : Pawl : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Operate rear wiper to the auto stop position. 2. Remo ...