Nissan Juke Service and Repair Manual : Door does not lock/unlock with intelligent key

Diagnosis Procedure

1.CHECK DTC WITH BCM AND TCM

Check that DTC is not detected with BCM and TCM.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to TM-171, "DTC Index" (RE0F10B models) or TM-366, "DTC Index" (RE0F11A models).

(TCM)

2.CHECK POWER DOOR LOCK OPERATION

Check door lock/unlock using door lock and unlock switch.

Does door lock/unlock using door lock and unlock switch? YES >> GO TO 3.

NO >> Refer to DLK-254, "Component Function Check".

3.CHECK REMOTE KEYLESS ENTRY RECEIVER

Check remote keyless entry receiver.

Refer to DLK-266, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK INTELLIGENT KEY

Check Intelligent Key.

Refer to DLK-262, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Door does not lock/unlock with door lock and unlock switch
    All door ALL DOOR : Description All doors do not lock/unlock using door lock and unlock switch. ALL DOOR : Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switc ...

    Ignition position warning function does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM. Is the inspection result normal? YES >> GO TO 2. NO >> Refer to BCS-67, "DTC Index". ...

    Other materials:

    Brake fluid
    Inspection BRAKE FLUID LEVEL • Check that the fluid level in the reservoir tank is within the specified range (MAX – MIN lines). • Visually check for any brake fluid leakage around the reservoir tank. • Check the brake system for any leakage if the fluid level is extremely low (lower ...

    Engine unit
    Disassembly 1. Remove intake manifold. Refer to EM-28, "Exploded View". 2. Remove catalyst convertor. Refer to EM-33, "2WD : Exploded View" (2WD models) or EM-34, "4WD : Exploded View" (4WD models). 3. Remove turbocharger. Refer to EM-36, "Exploded View" ...

    B1050, B1055 driver air bag module
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...