Nissan Juke Service and Repair Manual : 4WD mode indicator lamp (4WD)

Component Function Check

1.4WD MODE INDICATOR LAMP OPERATION CHECK

Check that 4WD mode indicator lamp (4WD) turns on for approximately 1 second after the ignition switch is turned ON.

Is the inspection result normal? YES >> INSPECTION END

NO >> Proceed to diagnosis procedure. Refer to DLN-82, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK 4WD WARNING LAMP

Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.

Does 4WD warning lamp turn ON? YES >> Proceed to DLN-80, "Diagnosis Procedure".

NO >> GO TO 2.

2.CHECK 4WD MODE SWITCH

Perform the trouble diagnosis for 4WD mode switch. Refer to DLN-44, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the error-detected parts.

3.CHECK 4WD MODE INDICATOR LAMP SIGNAL

1. Start the engine.With CONSULT-III


1. Start the engine.

CAUTION:
Stop the vehicle.

2. Change 4WD mode switch to “4WD” from “4WD-V”.

3. Check “INDICATOR” of CONSULT-III “DATA MONITOR” for “ALL MODE AWD/4WD”.

Does the item on “DATA MONITOR” indicate “4WD”? YES >> GO TO 4.

NO >> Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

4.CHECK COMBINATION METER POWER SUPPLY CIRCUIT

Perform the trouble diagnosis for combination meter power supply circuit. Refer to MWI-51, "COMBINATION METER : Diagnosis Procedure".

Is the inspection result normal? YES >> INSPECTION END

NO >> Repair or replace the error-detected parts.

    4WD mode indicator lamp (4WD-V)
    Component Function Check 1.4WD MODE INDICATOR LAMP OPERATION CHECK 1. Turn the ignition switch ON. 2. Change 4WD mode switch to “4WD-V”. 3. Check that 4WD mode indicator lamp (4WD-V) turns on. ...

    Other materials:

    Side oil seal
    Removal and Installation REMOVAL 1. Remove front drive shafts. (MR16DDT) Refer to FAX-22, "LEFT SIDE : Removal and Installation" (LEFT SIDE) and FAX-24, "RIGHT SIDE : Removal and Installation" (RIGHT SIDE). 2. Remove front drive shafts. (K9K) Refer to FAX-78, "LEFT SID ...

    P0335 CKP sensor (POS)
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0340 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to EC-307, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perfo ...

    C1155 brake fluid level switch
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...