Nissan Juke Service and Repair Manual : P1740 select solenoid

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.

NOTE:

If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

1.CHECK DTC DETECTION

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Select “DATA MONITOR” in “TRANSMISSION”.

3. Start engine and maintain the following conditions for at least 5 consecutive seconds.

RANGE : “D” position and “N” positions (At each time, wait for 5 seconds.)

Follow the procedure “With CONSULT-III”.With GST


Follow the procedure “With CONSULT-III”.

Is “P1740” detected? YES >> Go to TM-247, "Diagnosis Procedure".

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

Component Inspection

LOCK-UP SELECT SOLENOID VALVE

1.LOCK-UP SELECT SOLENOID VALVE

1. Turn ignition switch OFF.

2. Disconnect CVT unit harness connector.

3. Check resistance between CVT unit harness connector terminal and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> Replace the transaxle assembly. Refer to TM-301, "Removal and Installation".

    P1726 throttle control signal
    Description Electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor etc. The actuator sends a signal to the ECM, and ECM ...

    P1745 line pressure control
    Description The line pressure solenoid valve regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC D ...

    Other materials:

    Fluid cooler system
    Exploded View 1. Copper washer 2. CVT fluid cooler tube 3. Hose clamp 4. Fluid cooler hose A 5. Fluid cooler tube 6. Fluid cooler hose B 7. Fluid cooler hose C 8. Transaxle assembly 9. Fluid cooler hose D 10. Fluid cooler hose E 11. Fluid cooler hose F 12. Bypass valve 13. Flu ...

    Where to go for service
    If maintenance service is required or your vehicle appears to malfunction, have the systems checked and serviced by a NISSAN dealer. NISSAN technicians are well-trained specialists and are kept up-to-date with the latest service information through technical bulletins, service tips, and in-deal ...

    Unbalance steering wheel turning force (torque variation)
    Description Unbalance steering wheel turning force (torque variation). Diagnosis Procedure 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check the EPS warning lamp while engine is running. Does the EPS warning lamp turn OFF? YES >> GO TO 2. NO >> Refer to STC-28, "Diag ...