Nissan Juke Service and Repair Manual : DTC/Circuit diagnosis
- U1000 can comm circuit
- U1010 control unit (CAN)
- P0703 brake switch B
- P0705 transmission range switch A
- P0710 transmission fluid temperature sensor A
- P0715 input speed sensor A
- P0717 input speed sensor A
- P0720 output speed sensor
- P0725 engine speed
- P0730 incorrect gear ratio
- P0730 incorrect gear ratio
- P0744 torque converter
- P0745 pressure control solenoid A
- P0746 pressure control solenoid A
- P0776 pressure control solenoid B
- P0778 pressure control solenoid B
- P0826 up and down shift SW
- P0840 transmission fluid pressure SEN/SW A
- P0841 transmission fluid pressure SEN/SW A
- P0868 transmission fluid pressure
- P1585 G sensor
- P1701 TCM
- P1705 TP sensor
- P1722 vehicle speed
- P1723 speed sensor
- P1726 throttle control signal
- P1740 select solenoid
- P1745 line pressure control
- P1777 step motor
- P1778 step motor
- Shift position indicator circuit
- Shift lock system
CVT position
Inspection and Adjustment
INSPECTION
1. Place selector lever in “P” position, and turn ignition switch ON (engine
stop).
2. Make sure that selector lever can be shifted to other than “P” position ...
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellen ...
Other materials:
C1109 power and ground system
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...
P17B8 high clutch solenoid
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
1. S ...
P1544 EGT sensor 2
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P1544 is displayed with DTC P0115, first perform trouble diagnosis for
DTC P0115. Refer to EC-907,
"DTC Logic".
Diagnosis Procedure
1.CHECK GROUND CONNECTIONS
1. Turn ignition switch OFF.
2. Check ground connection E38. Refer to Ground ...
