Nissan Juke Service and Repair Manual : 4WD mode indicator lamp (4WD-V)

Component Function Check

1.4WD MODE INDICATOR LAMP OPERATION CHECK

1. Turn the ignition switch ON.

2. Change 4WD mode switch to “4WD-V”.

3. Check that 4WD mode indicator lamp (4WD-V) turns on.

Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to diagnosis procedure. Refer to DLN-81, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK 4WD WARNING LAMP

Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.

Does 4WD warning lamp turn ON? YES >> Proceed to DLN-80, "Diagnosis Procedure".

NO >> GO TO 2.

2.CHECK 4WD MODE SWITCH

Perform the trouble diagnosis for 4WD mode switch. Refer to DLN-44, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the error-detected parts.

3.CHECK 4WD MODE INDICATOR LAMP SIGNAL

1. Start the engine.With CONSULT-III


1. Start the engine.

CAUTION:
Stop the vehicle.

2. Change 4WD mode switch to “4WD-V” from “2WD”.

3. Check “INDICATOR” of CONSULT-III “DATA MONITOR” for “ALL MODE AWD/4WD”.

Does the item on “DATA MONITOR” indicate “4WD-V”? YES >> GO TO 4.

NO >> Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

4.CHECK COMBINATION METER POWER SUPPLY CIRCUIT

Perform the trouble diagnosis for combination meter power supply circuit. Refer to MWI-51, "COMBINATION METER : Diagnosis Procedure".

Is the inspection result normal? YES >> INSPECTION END

NO >> Repair or replace the error-detected parts.

    4WD warning lamp
    Component Function Check 1.CHECK 4WD WARNING LAMP FUNCTION 1. Turn the ignition switch ON. 2. Check that 4WD warning lamp turns on. Is the inspection result normal? YES >> INSPECTION END ...

    4WD mode indicator lamp (4WD)
    Component Function Check 1.4WD MODE INDICATOR LAMP OPERATION CHECK Check that 4WD mode indicator lamp (4WD) turns on for approximately 1 second after the ignition switch is turned ON. Is the i ...

    Other materials:

    P1572 ASCD brake switch
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1572 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. Refer to EC-683, "DTC Logic". • This self-diagnosis has the one trip detection logic. When malfunction A is detected, DTC is not stored in ECM me ...

    Air breather hose
    MR16DDT : Exploded View 1. Clip 2. Air breather hose 3. 2 way connector MR16DDT : Removal and Installation REMOVAL 1. Remove air cleaner case. Refer to EM-26, "Removal and Installation". 2. Remove clips (1). : Vehicle front 3. Remove air breather hose from the 2 way connector. ...

    A/C control
    Exploded View 1. Intake door cable 2. Air mix door cable 3. Mode door cable 4. A/C control 5. Intake door lever knob A. To intake door link B. To air mix door link C. To mode door link Removal and Installation REMOVAL 1. Remove A/C finisher. Refer to IP-13, "Removal and Instal ...