Nissan Juke Service and Repair Manual : Component parts
Component Parts Location
1. Intelligent Key warning buzzer
2. Remote keyless entry receiver
3. Inside key antenna (instrument center)
4. TCM
Refer to TM-133, "CVT CONTROL
SYSTEM : TCM" (RE0F10B models)
or TM-316, "CVT CONTROL SYSTEM
: TCM" (RE0F11A models)
5. Push-button ignition switch
6. Combination meter
7. BCM
Refer to BCS-6, "BODY CONTROL
SYSTEM : Component Parts Location"
8. Power window switch (driver side)
(door lock and unlock switch)
9. Outside key antenna (driver side)
10. Front door switch (driver side)
11. Front door lock assembly (driver side)
12. Front door request switch (driver side)
13. Inside key antenna (console)
14. Inside key antenna (luggage room)
15. Back door request switch
16. Back door lock assembly
17. Outside antenna (rear bumper)
18. Front door request switch (passenger
side)
19. Outside key antenna (passenger side)
20. Air bag diagnosis sensor unit
Refer to SRC-7, "Component Parts
Location"
A. View with front bumper removed
B. View with instrument panel assembly
removed
C. View with multi display unit removed
D. View with center console assembly removed
E. View with luggage room finisher removed
F. View with rear bumper removed
Component Description
System (power door lock system)
System Diagram
System Description
DOOR LOCK FUNCTION
Door Lock and Unlock Switch
• The door lock and unlock switch (driver side) is build into power window main
switch.
• Interlocked with ...
Other materials:
Diagnosis system (BCM) (without intelligent key system)
Common item : consult-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for ...
P1551, P1552 battery current sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. ...
Fender protector
Exploded View
1. Hoodledge insurator
2. Fender protector
3. U nut
4. Air guide
5. Screw grommet
A. To hoodledge panel
: Vehicle front
Removal and Installation
REMOVAL
1. Remove front fillet molding. Refer to EXT-26, "FRONT FILLET MOLDING :
Removal and Installation".
2. Re ...
