Nissan Juke Service and Repair Manual : Parking brake switch signal circuit

Diagnosis Procedure

1.CHECK COMBINATION METER INPUT SIGNAL

1. Turn ignition switch ON.

2. Check the voltage between combination meter harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> GO TO 2.

2.CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect combination meter connector and parking brake switch connector.

3. Check continuity between combination meter harness connector and parking brake switch harness connector.

4. Check continuity between combination meter harness connector and ground.


4. Check continuity between combination meter harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> Repair harness or connector

Component Inspection

1.CHECK PARKING BRAKE SWITCH

Check parking brake switch. Refer to BRC-208, "Component Inspection" (with ESP) or BRC-70, "Component Inspection" (without ESP).

Is the inspection result normal? YES >> INSPECTION END.

NO >> Replace parking brake switch. Refer to PB-4, "Exploded View".

    Meter buzzer circuit
    Component Function Check 1.CHECK OPERATION OF METER BUZZER 1. Select “BUZZER” of “BCM” on CONSULT-III. 2. Perform “LIGHT WARN ALM” of “Active Test”. Does meter buzzer beep? YES ...

    Other materials:

    For side and rollover collision : When SRS is activated in a collision
    CAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles. WORK PROCEDURE 1. Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed. 2. Replace the following components: ...

    Camshaft valve clearance
    Valve Clearance CHECKING AND ADJUSTING THE VALVE CLEARANCE 1. Install the tappet. 2. Install the camshaft. 3. Install the camshaft brackets. : 11 N·m (1.1 kg-m, 8 ft-lb) 4. Place the valves of the cylinder concerned at the “end of exhaust - beginning of inlet” position and check the clea ...

    B1177 lap Pre-tensioner RH
    DTC Logic DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSTIC RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp status. Refe ...