Parking brake switch signal circuit

Diagnosis Procedure 1.CHECK COMBINATION METER INPUT SIGNAL 1. Turn ignition switch ON. 2. Check the voltage between combination meter harness connector and ground. Is the inspection result norma ...

The parking brake release warning continues sounding, or does not sound

Description • The parking brake warning buzzer sounds continuously during vehicle travel though the parking brake is released. • The parking brake warning buzzer does not sound at all even th ...

Other materials:

C1111 ABS motor, motor relay system
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...

Super lock actuator
Driver side DRIVER SIDE : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “SUPER LOCK” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result n ...

System (power door lock system)
System Diagram System Description DOOR LOCK FUNCTION Door Lock and Unlock Switch • The door lock and unlock switch (driver side) is build into power window main switch. • Interlocked with the locking operation of door lock and unlock switch, door lock actuators of all doors are locke ...