Nissan Juke Service and Repair Manual : The key warning does not sound (without intelligent key)

Nissan Juke Service and Repair Manual / Warning Chime System / Symptom diagnosis / The key warning does not sound (without intelligent key)

Description

The key warning chime does not sound, when all of the following conditions are fulfilled.

• Key inserted into the key cylinder (key switch signal ON).

• Ignition switch is in ACC or OFF (ignition switch signal OFF).

• Driver side door is open (driver side door switch ON)

Diagnosis Procedure

1.CHECK BCM INPUT SIGNAL

1. Connect CONSULT-III.

2. Select the “Data Monitor” of “BCM (BUZZER)” and check the “KEY ON SW” monitor value. Refer to WCS- 21, "BUZZER : CONSULT-III Function (BCM - BUZZER)".

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-161, "Removal and Installation".

NO >> GO TO 2.

2.CHECK KEY SWITCH SIGNAL CIRCUIT

Check the key switch signal circuit. Refer to DLK-401, "Diagnosis Procedure" (Type 3) or DLK-526, "Diagnosis Procedure" (Type 4).

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-161, "Removal and Installation".

NO >> Check applicable parts, and repair or replace corresponding parts.

NOTE

:
To identify vehicle type, refer to DLK-357, "Information".

    The seat belt reminder warning continues sounding, or does not sound
    Description • Seat belt reminder warning does not sound. • Seat belt reminder warning sounds continuously. Diagnosis Procedure 1.CHECK SEAT BELT WARNING LAMP 1. Turn ignition switch ON. 2. C ...

    Other materials:

    P0743 torque converter
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE OPERATION (PART 1) If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next ...

    Service Notice
    • When removing or installing various parts, place a cloth or padding onto the vehicle body to prevent scratches. • Handle trim, molding, instruments, grille, etc. carefully during removing or installing. Be careful not to oil or damage them. • Apply sealing compound where necessary wh ...

    Front fender
    Exploded View 1. Front fender assembly 2. Front fender stiffener : Vehicle front Removal and Installation REMOVAL 1. Remove front fillet molding. Refer to EXT-26, "FRONT FILLET MOLDING : Removal and Installation". 2. Remove front bumper fascia assembly. Refer to EXT-13, "R ...