Nissan Juke Service and Repair Manual : The light reminder warning does not sound
Description
Light reminder warning chime does not sound even though headlamp is illuminated.
Diagnosis Procedure
1.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION
Check that the headlamps operate normally by operating the combination switch (lighting switch).
Do they operate normally? YES >> GO TO 2.
NO >> Refer to EXL-75, "WITH DAYTIME RUNNING LIGHT SYSTEM : Symptom Table" (with daytime running light system) or EXL-74, "WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Symptom Table" (without daytime running light system).
2.CHECK DRIVER SIDE DOOR SWITCH SIGNAL CIRCUIT
Perform the check for the driver side door switch signal circuit. Refer to DLK-87, "Diagnosis Procedure" (Type 1), DLK-258, "Diagnosis Procedure" (Type 2), DLK-397, "Diagnosis Procedure" (Type 3), or DLK-522, "Diagnosis Procedure" (Type 4).
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair harness or connector.
3.CHECK DRIVER SIDE DOOR SWITCH
Perform a unit check for the driver side door switch. Refer to DLK-88, "Component Inspection" (Type 1), DLK- 259, "Component Inspection" (Type 2), DLK-398, "Component Inspection" (Type 3), or DLK-523, "Component Inspection" (Type 4).
Is the inspection result normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation" (with intelligent key system) or BCS- 161, "Removal and Installation" (without intelligent key system).
NO >> Replace driver side door switch. Refer to DLK-187, "Removal and Installation" (Type 1), DLK-350, "Removal and Installation" (Type 2), DLK-485, "Removal and Installation" (Type 3), or DLK-601, "Removal and Installation" (Type 4).
NOTE
:
To identify vehicle type, refer to DLK-17, "Information".
The parking brake release warning continues sounding, or
does not sound
Description
• The parking brake warning buzzer sounds continuously during vehicle travel
though the parking brake is
released.
• The parking brake warning buzzer does not sound at all even though ...
The seat belt reminder warning continues sounding, or
does not sound
Description
• Seat belt reminder warning does not sound.
• Seat belt reminder warning sounds continuously.
Diagnosis Procedure
1.CHECK SEAT BELT WARNING LAMP
1. Turn ignition switch ON.
2. Check ...
Other materials:
P0117, P0118 ECT sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
Inspection
INSPECTION AFTER REMOVAL
Check the following items, and replace the part if necessary.
• Move joint up/down, left/right, and in the axial directions. Check for motion
that is not smooth and for significant
looseness.
• Check boot for cracks, damage, and leakage of grease.
• Check the suppor ...
IPDM-E branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose
connection (unit side
and connector side).
Is the inspection result normal?
Y ...
