Nissan Juke Service and Repair Manual : Diagnosis system (BCM) (without intelligent key system) common item

Nissan Juke Service and Repair Manual / Warning Chime System / System description / Diagnosis system (BCM) (without intelligent key system) common item

Common item : consult-III Function (BCM - common item)

APPLICATION ITEM

CONSULT-III performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION


SYSTEM APPLICATION

BCM can perform the following functions for each system.

NOTE

:
It can perform the diagnosis modes except the following for all sub system selection items.

• *1: This item is displayed, but is not used.


• *1: This item is displayed, but is not used.

• *2: For models with automatic A/C, this mode is not used.

Buzzer

BUZZER : CONSULT-III Function (BCM - BUZZER)

CONSULT-III APPLICATION ITEMS

DATA MONITOR


DATA MONITOR

ACTIVE TEST


ACTIVE TEST

Ecu diagnosis information


    Diagnosis system (bcm) (with intelligent key system)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perfo ...

    Other materials:

    Sensor rotor
    Front sensor rotor : Removal and Installatio REMOVAL Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled. • MR16DDT: Refer to FAX-11, "Removal and Installation". • HR16DE: Refer to FAX-43, "Removal and Installation". • K9K: Refer t ...

    Lubricant
    Description MAINTENANCE OF LUBRICANT LEVEL The compressor lubricant is circulating in the system together with the refrigerant. It is necessary to fill compressor with lubricant when replacing A/C system parts or when a large amount of refrigerant leakage is detected. It is important to alwa ...

    P0197, P0198 EOT sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...