Nissan Juke Owners Manual : Checking bulbs

With all doors closed, apply the parking brake and place the ignition switch in the ON position without starting the engine. The following lights will come on: or,
, or
,,
,,
,,
,,
,
The following lights come on briefly and then go off (if so equipped):


The following lights come on briefly and then go off (if so equipped):

or,
, or
,,
,,
,,
,,
,,
,,
,,
,,
,
If any light does not come on, it may indicate a burned-out bulb or an open circuit


If any light does not come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system checked by a NISSAN dealer.

    Warning lights
    All-Wheel Drive (AWD) warning light (AWD model) When the ignition switch is in the “ON” position, the All-Wheel Drive (AWD) warning light will illuminate. It will turn off soon after the eng ...

    Other materials:

    B1185 lap Pre-tensioner LH
    DTC Logic DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSTIC RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp status. Refe ...

    FM-AM-SAT radio with Compact Disc (CD) player (Type B)
    1. XM band select button 2. CD insert slot 3. CD EJECT button 4. TUNE/SCROLL knob and AUDIO control button 5. Radio station preset buttons 6. AUX button 7. ON·OFF button/VOLUME control knob 8. FF (forward)/REW (rewind) or SEEK/CATEGORY button 9. CD button 10. FM·AM band select button N ...

    P1804, P1809 4WD control module
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...