Fog light switch (if so equipped)

To turn the fog lights on, turn the headlight switch to the position, then turn the switch to the position. To turn them off, turn the switch to the OFF position. The headlights must be on fo ...

Vehicle Dynamic Control (VDC) off switch

The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to re ...

Other materials:

P1715 input speed sensor
Description ECM receives input speed sensor signal from TCM via the CAN communication line. ECM uses this signal for engine control. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. • If DTC P1715 is display ...

P1197 out of gas
Description This diagnosis result is detected when the fuel level of the fuel tank is extremely low and the engine does not run normally. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition ...

Vehicle Recovery (Freeing a Stuck Vehicle)
FRONT 1. Remove the hook cover from the bumper using a remover tool. 2. Securely install the vehicle recovery hook stored with jacking tools. Check that the hook is properly secured in the stored place after use. WARNING: • Stand clear of a stuck vehicle. • Never spin your tires at high spe ...