Power outlet

The power outlet is located in the instrument panel. CAUTION • The outlet and plug may be hot during or immediately after use. • Do not use with accessories that exceed a 12 volt, 120W (10A) ...

Cup holders

CAUTION •  Avoid abrupt starting and braking when the cup holder is being used to prevent spilling the drink. If the liquid is hot, it can scald you or your passenger. • Use only soft cup ...

Other materials:

P0641 sensor power supply
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground Inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or r ...

Sensor rotor
Front sensor rotor : Removal and Installation REMOVAL Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled. Refer to FAX-43, "Removal and Installation". INSTALLATION Replace wheel hub as an assembly when replacing because sensor rotor cannot ...

Performance test
Inspection INSPECTION PROCEDURE 1. Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge. 2. Start the engine, and set to the following condition. Test condition 3. Maintain test condition until A/C system becomes stable. (Approximately 10 minutes) 4. Check t ...