Nissan Juke Service and Repair Manual : Component Inspection (Low Brake Solenoid Valve)

1.CHECK LOW BRAKE SOLENOID VALVE

Check the resistance between the CVT unit connector terminal and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> There is a malfunction of the low brake solenoid valve. Replace the transaxle assembly. Refer to TM-508, "Removal and Installation".

    P17B5 low brake solenoid
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for a ...

    P17B7 high clutch solenoid
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for a ...

    Other materials:

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-vehicle multiplex communication system with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto vehicles, and ea ...

    Blower fan resistor
    Exploded View 1. A/C unit assembly 2. Fan control amp.*1 3. Blower fan resistor*2 4. Blower motor 5. Blower motor cover • *1: Automatic air conditioner • *2: Manual air conditioner Removal and Installation REMOVAL 1. Remove instrument panel assembly. Refer to IP-13, "Removal ...

    Starter motor drive control
    Starter motor drive control : System Diagram Starter motor drive control : System DescriptionINPUT/OUTPUT SIGNAL CHART INPUT/OUTPUT SIGNAL CHART *: With Intelligent Key system SYSTEM DESCRIPTION When rapid deceleration occurs during engine runs or idle speed decreases due to heavy load c ...