Nissan Juke Service and Repair Manual : P062f eeprom

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

1. Start the engine.

2. Check the first trip DTC.

Is “P062F” detected? YES >> Go to TM-393, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK INTERMITTENT INCIDNT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace the TCM. Refer to TM-490, "Removal and Installation".

NO >> Repair or replace the malfunctioning parts.

    U1119 lost comm (multi-display)
    Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

    P0705 transmission range switch A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just befor ...

    Other materials:

    Hood
    Exploded View 1. Hood assembly 2. Hood bumper rubber 3. Radiator core seal 4. Hood bumper rubber 5. Clamp 6. Hood hinge 7. Grommet 8. Hood support rod : Clip : Pawl : Body grease Hood assembly HOOD ASSEMBLY : Removal and Installation CAUTION: • Operate with two workers, becau ...

    Road test
    Description DESCRIPTION • The purpose of the test is to determine overall performance of CVT and analyze causes of problems. • The road test consists of the following three parts: 1. “Check Before Engine Is Started” TM-190. 2. “Check at Idle” TM-191. 3. “Cruise Test” TM-192. ...

    Positive crankcase ventilation
    Inspection 1.CHECK PCV VALVE With engine running at idle, remove PCV valve from rocker cover. A properly working valve makes a hissing noise as air passes through it. A strong vacuum should be felt immediately when a finger is placed over valve inlet. Is the inspection result normal? YES &g ...