Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- C1101, C1102, C1103, C1104 wheel sensor
- C1105, C1106, C1107, C1108 wheel sensor
- C1109 power and ground system
- C1110, C1170 ABS actuator and electric unit (control unit)
- C1111 ABS motor, motor relay system
- C1113, C1145, C1146 yaw rate/side/decel g sensor
- C1115 wheel sensor
- C1116 stop lamp switch
- C1120, C1122, C1124, C1126 ABS in valve system
- C1121, C1123, C1125, C1127 ABS out valve system
- C1130 engine signal
- C1140 actuator relay system
- C1142 press sensor
- C1143 steering angle sensor
- C1144 incomplete steering angle sensor adjustment
- C1155 brake fluid level switch
- C1164, C1165 CV system
- C1166, C1167 SV system
- C1176 stop lamp SW2
- U1000 can comm circuit
- U1010 control unit (can)
- Power supply and ground circuit
- Parking brake switch
- ESP off switch
- ABS warning lamp
- Brake warning lamp
- ESP warning lamp
- ESP off indicator lamp
Adjustment of steering angle sensor neutral position
Description
Always adjust the neutral position of steering angle sensor before driving
when the following operation is performed.
Work Procedure
ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SE ...
C1101, C1102, C1103, C1104 wheel sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least ...
Other materials:
Cylinder block
Disassembly and Assembly
PREPARING USED ENGINE
The engine should be cleaned and drained (oil and water).
Leave on the used engine or include in the return box:
• Oil filter
• Oil pressure switch
• Water pump
• Fuel injection pump
• Rail
• Injectors
• Glow plugs
• Oil lev ...
Fuses
Motor compartment
WARNING
Under no circumstances should you touch, disassemble, remove, or replace any high-voltage components, cables, or their associated connectors. High-voltage cables in your Nissan Leaf are identified by their distinctive orange outer i ...
Wiring diagram
NISSAN DYNAMIC CONTROL SYSTEM
Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
