Nissan Juke Service and Repair Manual : ESP off indicator lamp

Component Function Check

1.CHECK ESP OFF INDICATOR LAMP FUNCTION (1)

Check that ESP OFF indicator lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON.

CAUTION:
Never start engine.

Is the inspection result normal? YES >> GO TO 2.

NO >> Proceed to diagnosis procedure. Refer to BRC-215, "Diagnosis Procedure".

2.CHECK ESP INDICATOR LAMP FUNCTION (2)

Check that ESP OFF indicator lamp in combination meter turns ON/OFF when ESP OFF switch is operated.

Is the inspection result normal? YES >> INSPECTION END

NO >> Check ESP OFF switch system. Refer to BRC-210, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit.

Refer to BRC-205, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace error-detected parts.

2.CHECK ESP OFF INDICATOR LAMP SIGNAL (1)

1. Select “ABS”, “DATA MONITOR” and “OFF LAMP” according to this order.With CONSULT-III.


1. Select “ABS”, “DATA MONITOR” and “OFF LAMP” according to this order.

2. Turn the ignition switch OFF.

3. Check that data monitor displays “On” for approx. 1 second after ignition switch is turned ON, and then changes to “Off”.

CAUTION:
Never start engine

.

Is the inspection result normal? YES >> GO TO 3.

NO >> Replace ABS actuator and electric unit (control unit). Refer to BRC-233, "Removal and Installation".

3.CHECK ESP OFF INDICATOR LAMP SIGNAL (2)

1. Select “ABS”, “DATA MONITOR” and “OFF LAMP” according to this order.With CONSULT-III.


1. Select “ABS”, “DATA MONITOR” and “OFF LAMP” according to this order.

2. Check that data monitor displays “On” or “Off” each time when ESP OFF switch is operated.

Is the inspection result normal? YES >> Check combination meter. Refer to MWI-23, "CONSULT-III Function".

NO >> Check ESP OFF switch system. Refer to BRC-210, "Diagnosis Procedure".

    ESP warning lamp
    Component Function Check 1.CHECK ESP WARNING LAMP FUNCTION Check that ESP warning lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON. CAUTION: Never st ...

    Other materials:

    Diagnosis system (BCM)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the ...

    EPS warning lamp does not turn on
    Description EPS warning lamp does not turn ON when turning ignition switch ON from OFF. (Check the illumination of the EPS warning lamp.) Diagnosis Procedure 1.CHECK EPS WARNING LAMP Perform the trouble diagnosis of EPS warning lamp. Refer to STC-26, "Diagnosis Procedure". Is t ...

    Exhaust gas (carbon monoxide)
    WARNING • Do not breathe exhaust gases; they contain colorless and odorless carbon monoxide. Carbon monoxide is dangerous. It can cause unconsciousness or death. • If you suspect that exhaust fumes are entering the vehicle, drive with all windows fully open, and have the vehicle inspected imme ...