Precaution for Harness Repair

• Solder the repair part, and wrap it with tape. [Twisted wire fray must be 110 mm (4.33 in) or less.] • Never bypass the repair point with wire. (If it is bypassed, the turnout point cannot be s ...

Component parts

Component Parts Location LHD 2WD 1. ECM Refer to EC-25, "ENGINE CONTROL SYSTEM : Component Parts Location" (MR16DDT), EC-455, "ENGINE CONTROL SYSTEM : Component Parts Locatio ...

Other materials:

B1147 curtain air bag module RH
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

P0045 TC boost control solenoid valve
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK TURBOCHARGER BOOST CONTROL SOLENOID VALVE POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect turbocharger boost control solenoid valve harness connector. 3. Turn ignition switch ON. 4. Check the voltage between turbochar ...

Sensor rotor
Front sensor rotor : Removal and Installatio REMOVAL Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled. • MR16DDT: Refer to FAX-11, "Removal and Installation". • HR16DE: Refer to FAX-43, "Removal and Installation". • K9K: Refer t ...