Nissan Juke Service and Repair Manual : How to use this manual
Information
Both “VDC” and “ESP” are used in this manual. These indicate the same system.
Precaution
...
Other materials:
SPEED LIMITER MAIN SWITCH
Component Function Check
1.CHECK SPEED LIMITER MAIN SWITCH FUNCTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select “SL MAIN SW” in “DATA MONITOR” mode of “ENGINE” using CONSULT-III.
3. Check “SL MAIN SW” indication as per the following condition.
Without CONSULT-III
...
Compression pressure
Inspection
1. Warm up engine thoroughly. Then, stop it.
2. Release fuel pressure. Refer to EC-551, "Work Procedure".
3. Remove ignition coil and spark plug from each cylinder. Refer to EM-53,
"Exploded View".
4. Connect engine tachometer (not required in use of CONSULT-II ...
Operation inspection
Work Procedure
The purpose of the operational check is to check that the individual system
operates normally.
Check condition : Engine running at normal operating temperature.
1.CHECK MEMORY FUNCTION
1. Set temperature to 30°C by operating the temperature control dial.
2. Press OFF switch.
...
