Nissan Juke Service and Repair Manual : Does not operate

Description

ESP function, TCS function, ABS function, EBD function and brake limited slip differential (BLSD) function does not operate.

Diagnosis Procedure

CAUTION:
• ESP function, TCS function, ABS function, EBD function and brake limited slip differential (BLSD) function never operate when the vehicle speed is 10 km/h (6.2 MPH) or less.

• ESP function and TCS function never operate when ESP OFF switch is operated (when ESP OFF indicator lamp turns ON).

1.CHECK WARNING LAMP

Check that ABS warning lamp, brake warning lamp and ESP warning lamp turn ON and turn OFF approx. 1 second after key switch is turned ON. Check that ABS warning lamp, brake warning lamp and ESP warning lamp and stay in OFF status during driving.

CAUTION:
Brake warning lamp turns ON when parking brake is operated (parking brake switch is ON) or brake fluid is less than the specified level (brake fluid level switch is ON).

Is the inspection result normal? YES >> Normal

NO >> Perform self-diagnosis for “ABS” with CONSULT-III.

    The braking distance is long
    Description Brake stopping distance is long when ABS function is operated. Diagnosis Procedure CAUTION: Brake stopping distance on slippery road like rough road, gravel road or snowy road may be ...

    Brake pedal vibration or operation sound occurs
    Description • Brake pedal vibrates and motor sound from ABS actuator and electric unit (control unit) occurs, when the engine starts. • Brake pedal vibrates during braking. CAUTION: Vibration ...

    Other materials:

    P1813 4WD mode switch
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

    Back door
    Exploded View REMOVAL 1. Back door weather-strip 2. Back door stay 3. Back door stay lower bracket 4. Bumper rubber 5. Back door striker 6. Back door panel 7. Back door hinge 8. Hole cover A : Center mark B : Seam : Do not reuse : Body grease Back door assembly BACK DOOR ASSEMB ...