Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all co ...

Precaution for Brake System

WARNING: Clean any dust from the front brake and rear brake using a vacuum dust collector. Never blow by compressed air. • Brake fluid use refer to MA-13, "Fluids and Lubricants". � ...

Other materials:

P1865 gear ratio signal
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

ECU diagnosis information
ABS actuator and electric unit (control unit) Reference Value CONSULT-III DATA MONITOR STANDARD VALUE *1: Confirm tire pressure is standard value. *2: Refer to “valve operation” in BRC-13, "System Description" for valve operation of each valve. *3: Refer to BRC-13, "Sys ...