Nissan Juke Service and Repair Manual : Intake sensor
Exploded View
Refer to HA-43, "Exploded View (Automatic Air Conditioning)". (HR16DE) Refer to HA-97, "Exploded View (Automatic Air Conditioning)". (MR16DDT)
Removal and Installation
REMOVAL
1. Remove evaporator.
• Refer to HA-55, "EVAPORATOR : Removal and Installation". (HR16DE) • Refer to HA-115, "EVAPORATOR : Removal and Installation". (MR16DDT)
2. Remove intake sensor from evaporator.
INSTALLATION
Note the following items, and then install in the order of removal.
CAUTION:
• Replace O-rings with new ones. Then apply the compressor oil to them when
installing.
• Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position.
• Never rotate the bracket insertion part when removing and installing the intake sensor.
• Check for leakages when recharging refrigerant. Refer to HA-19, "Leak Test". (HR16DE) or HA-74, "Leak Test". (MR16DDT
)
Sunload sensor
Removal and Installation
REMOVAL
1. Remove switch panel. Refer to IP-13, "Removal and Installation".
2. Disconnect sunload sensor connector, and then remove sunload sensor.
INSTALLATIO ...
Refrigerant pressure sensor
Exploded View
Refer to HA-39, "Exploded View". (HR16DE)
Refer to HA-94, "Exploded View". (MR16DDT)
Removal and Installation
REMOVAL
Refer to HA-42, "REFRIGERANT PRESSURE ...
Other materials:
B2192 ID discord, IMMU-ECM
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Go to SEC-60, "Diagnosis Procedure".
NO &g ...
U0140 lost communication (BCM)
Description
CAN (Controller Area Network) is a serial communication line for real-time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent malfunction
detection ability.
Many electronic control units are equipped onto a vehicle, and ...
Diagnosis system (BCM) (without intelligent key system)
common item
Common item : consult-III Function (BCM - common item)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for ...
