Nissan Juke Service and Repair Manual : Removal and installation
- Controller
- A/C auto AMP
- Ambient sensor
- In-vehicle sensor
- Sunload sensor
- Intake sensor
- Refrigerant pressure sensor
- Fan control amplifier
- Door motor
Compressor dose dot operate
Description
SYMPTOM
Compressor dose not operate.
Diagnosis Procedure
NOTE:
• Perform self-diagnoses with CONSULT-III before performing symptom diagnosis.
If any DTC is detected,
perform the ...
Controller
Removal and Installation
REMOVAL
Remove multi display unit. Refer to IP-13, "Removal and Installation".
INSTALLATION
Install in the reverse order of removal. ...
Other materials:
P1805 brake switch
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Fully depress the brake pedal for at least 5 seconds.
3. Erase the DTC.
4. Check 1st trip DTC.
Is 1st trip DTC detected?
YES >> Proceed to EC-374, "Dia ...
Changing wheels and tires
Tire rotation
To ensure even tread wear and extend the lifespan of your tires, NISSAN strongly recommends rotating the tires on your Nissan Leaf every 7,500 miles (12,000 km).
As soon as possible after any wheel removal, tighten the wheel nuts to the factory-specified ...
Squeak and rattle trouble diagnoses
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any of
customer's comments; refer to DLK-553, &quo ...
