Nissan Juke Service and Repair Manual : Sunload sensor
Removal and Installation
REMOVAL
1. Remove switch panel. Refer to IP-13, "Removal and Installation".
2. Disconnect sunload sensor connector, and then remove sunload sensor.
INSTALLATION
Install in the reverse order of removal.
In-vehicle sensor
Removal and Installation
REMOVAL
1. Remove instrument lower panel (LH/RH). Refer to IP-13, "Removal and
Installation".
2. Remove fixing screw, and then remove in-vehicle sensor from ins ...
Intake sensor
Exploded View
Refer to HA-43, "Exploded View (Automatic Air Conditioning)". (HR16DE)
Refer to HA-97, "Exploded View (Automatic Air Conditioning)". (MR16DDT)
Removal and Installa ...
Other materials:
Radiator
Exploded View
1. Reservoir tank cap
2. Reservoir tank
3. Clamp
4. Reservoir tank hose
5. Mounting rubber (upper)
6. Reservoir tank hose
7. Radiator
8. Mounting rubber (lower)
9. Drain plug
10. O-ring
11. Cooling fan assembly
12. Radiator hose (upper)
13. Radiator hose (lower)
...
U1010 control unit (can)
Description
Initial diagnosis of A/C auto amp.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM SELF-DIAGNOSIS
With CONSULT-III
1. Turn ignition switch ON.
2. Select “Self Diagnostic Result” mode of “PTC HEATER” using CONSULT-.III
3. Check DTC.
Is DTC detected ...
Unit removal and installation
Transaxle assembly
Exploded View
1. CVT fluid level gauge
2. CVT fluid charging pipe
3. O-ring
4. Transaxle assembly
5. Air breather hose
A. For tightening torque, refer to TM-301, "Removal and Installation".
Removal and Intallation
REMOVAL
WARNING:
Never remove the reservo ...
