Nissan Juke Service and Repair Manual : In-vehicle sensor

Removal and Installation

REMOVAL

1. Remove instrument lower panel (LH/RH). Refer to IP-13, "Removal and Installation".

2. Remove fixing screw, and then remove in-vehicle sensor from instrument lower panel (LH/RH).

INSTALLATION

Install in the reverse order of removal.

    Ambient sensor
    Removal and Installation REMOVAL 1. Remove bumper fascia assembly. Refer to EXT-13, "Removal and Installation". 2. Disengage fixing pawl, and then remove ambient sensor (1) from air gu ...

    Sunload sensor
    Removal and Installation REMOVAL 1. Remove switch panel. Refer to IP-13, "Removal and Installation". 2. Disconnect sunload sensor connector, and then remove sunload sensor. INSTALLATIO ...

    Other materials:

    Hood lock
    Exploded View 1. Hood lock control cable assembly 2. Hood lock assembly : Clip : N·m (kg-m, ft-lb) : Body grease Hood lock HOOD LOCK : Removal and Installation REMOVAL 1. Remove front center grille. Refer to EXT-18, "Removal and Installation". 2. Remove crash zone sensor. Ref ...

    B2628 outside antenna
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Disconnect outside key antenna (rear bumper) connector. 2. Perform “INTELLIGENT KEY” Self Diagnostic Result. Is outside key antenna DTC detected? YES >> Refer to DLK-240, "Diagn ...

    Door does not lock/unlock with door lock and unlock switch
    All door ALL DOOR : Description All doors do not lock/unlock using door lock and unlock switch. ALL DOOR : Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switch. Refer to DLK-79, "DRIVER SIDE : Component Function Check". Is the inspection resu ...