Nissan Juke Service and Repair Manual : Heater & Air Conditioning Control System Type 2
- How to use this manual
- Precaution
- System description
- Component parts
- System
- Operation
- Diagnosis system (A/C auto AMP.)
- Diagnosis system (BCM) (with intelligent key system)
- Diagnosis system (BCM) (without intelligent key system)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B2578, B2579 In-vehicle sensor
- B257B, B257C ambient sensor
- B2581, B2582 intake sensor
- B2630, B2631 sunload sensor
- B2632, B2633 air mix door motor PBR
- B2636, B2637, B2638, B2639, B2654, B2655 mode door motor
- B263D, B263E, B263F intake door motor
- B27B0 A/C auto AMP.
- Power supply and ground circuit
- Door motor
- A/C on signal
- Blower fan on signal
- Blower motor
- Magnet clutch
- PTC heater
- Symptom diagnosis
- Removal and installation
Door motor
Exploded View
LEFT SIDE
1. A/C unit assembly
2. Intake door lever
3. Intake door motor
4. Air mix door motor
5. Upper air mix door rod
6. Upper air mix door lever
7. Lower air mix door l ...
How to use this manual
APPLICATION NOTICE
Information
Check the vehicle type to use the service information in this section.
...
Other materials:
B210B starter control relay
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B210B is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to PCS-
30, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press push-button ignition switch under the followin ...
If your vehicle overheats
CAUTION
• Do not continue to drive if your vehicle overheats. Doing so could cause
engine damage or a vehicle fire.
• To avoid the danger of being scalded, never remove the radiator cap while the
engine is still hot.
When the radiator cap is removed, pressurized hot water will spurt out, ...
Appearance and care
Removing spots
To preserve the pristine finish of your Nissan Leaf, it is essential to remove stubborn contaminants such as road tar, oil splatters, industrial fallout, insect residue, and tree sap as promptly as possible. If left to sit, these substances can chemically bond with or etch the pa ...
