Nissan Juke Service and Repair Manual : Controller
Removal and Installation
REMOVAL
Remove multi display unit. Refer to IP-13, "Removal and Installation".
INSTALLATION
Install in the reverse order of removal.
A/C auto AMP
Removal and Installation
REMOVAL
1. Remove audio unit. Refer to AV-38, "Removal and Installation".
2. Remove inside key antenna (instrument center). Refer to DLK-188, "INSTRUMENT
C ...
Other materials:
B1090, B1091, B1092, B1093, B1094, B1095 diagnosis sensor unit
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
P1642 thermoplunger control unit
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect thermoplunger control unit harness connector.
3. Check the voltage between thermoplunger control unit harness connector and
ground.
Is the ...
Engine stand setting
Setting
NOTE:
Explained here is how to disassemble with engine stand supporting transaxle
surface. When using different
type of engine stand, note with difference in steps and etc.
1. Remove the engine and the transaxle assembly from the vehicle, and separate
the transaxle from the
engine ...
