Nissan Juke Service and Repair Manual : B27B0 A/C auto AMP.

DTC Logic

DTC DETECTION LOGIC

NOTE

:
• If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 141, "DTC Logic".

• If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-142, "DTC Logic".

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III.

3. Check DTC.

Is DTC detected? YES >> Refer to HAC-161, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Proc

1.PERFORM SELF DIAGNOSTIC

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III.

3. Touch “ERASE”.

4. Turn ignition switch OFF.

5. Turn ignition switch ON.

6. Perform “DTC CONFIRMATION PROCEDURE”. Refer to HAC-161, "DTC Logic".

Is DTC detected again? YES >> Replace A/C auto amp. Refer to HAC-188, "Removal and Installation".

NO >> INSPECTION END

    B263D, B263E, B263F intake door motor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE With CONSULT-III 1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “HVA ...

    Power supply and ground circuit
    A/C auto AMP. : Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >>GO TO 2. B >>GO TO 5. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. ...

    Other materials:

    Glow plug
    Exploded View 1. Glow plug Engine front : N·m (kg-m, ft-lb) Removal and Installation REMOVAL CAUTION: Remove glow plug only if necessary. If carbon adheres, it may be stuck and broken. 1. Disconnect the battery cable from the negative terminal. 2. Remove cowl top extension. Refer to E ...

    Liquid Gasket
    REMOVAL OF LIQUID GASKET SEALING • After removing mounting nuts and bolts, separate the mating surface using the seal cutter [SST: KV10111100] (A) and remove old liquid gasket sealing. CAUTION: Be careful not to damage the mating surfaces. • Tap the seal cutter [SST: KV10111100] to inser ...

    On Board Diagnostic (OBD) System of Engine and CVT
    The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration. CAUTION: • Be sure to turn the ignition switch OFF and disconnect the negative battery cable before any repair or inspectio ...