Nissan Juke Service and Repair Manual : Ambient sensor
Removal and Installation
REMOVAL
1. Remove bumper fascia assembly. Refer to EXT-13, "Removal and Installation".
2. Disengage fixing pawl, and then remove ambient sensor (1) from air guide RH.
: Pawl
3. Disconnect ambient sensor connector (2), and then remove ambient sensor.
INSTALLATION
Install in the reverse order of removal.
A/C auto AMP
Removal and Installation
REMOVAL
1. Remove audio unit. Refer to AV-38, "Removal and Installation".
2. Remove inside key antenna (instrument center). Refer to DLK-188, "INSTRUMENT
C ...
In-vehicle sensor
Removal and Installation
REMOVAL
1. Remove instrument lower panel (LH/RH). Refer to IP-13, "Removal and
Installation".
2. Remove fixing screw, and then remove in-vehicle sensor from ins ...
Other materials:
Vehicle Dynamic Control (VDC) system
The Vehicle Dynamic Control (VDC) system uses various sensors to monitor driver
inputs and vehicle motion. Under certain driving conditions, the VDC system helps
to perform the following functions.
• Controls brake pressure to reduce wheel slip on one slipping drive wheel so
power is transf ...
Changing a flat tire
If you have a flat tire, follow the instructions below.
Stopping the vehicle
1. Safely move the vehicle off the road and away from traffic.
2. Turn on the hazard warning flashers.
3. Park on a level surface and apply the parking brake.
4. Continuously Variable Transmission (CVT) models:
Move t ...
BCM
LHD
LHD : Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
