Nissan Juke Service and Repair Manual : 4WD warning lamp does not turn on

Description

4WD warning lamp does not turn ON when the ignition switch is turned to ON.

Diagnosis Procedure

1.CHECK 4WD WARNING LAMP

Perform the trouble diagnosis for 4WD warning lamp. Refer to DLN-80, "Diagnosis Procedure".

Is the inspection result normal? YES >> Check each harness connector pin terminal for malfunction or disconnection.

NO >> Repair or replace the error-detected parts.

    4WD warning lamp does not turn off
    Description 4WD warning lamp does not turn OFF several seconds after the engine started. Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS With CONSULT-III Perform self-diagnosis for “ALL MODE AWD/4 ...

    Other materials:

    How to enable/disable the RCTA system
    Follow these steps to customize or toggle the RCTA system settings: 1. Press the button repeatedly until "Settings" appears on the vehicle information display. Use the button to navigate to "Driver Assistance," then press the OK button to enter the s ...

    P0524 engine oil pressure
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0524 is displayed with DTC P0520, P0075, or P0081, perform trouble diagnosis for DTC P0520, P0075, or P0081 first. Refer to EC-176, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previo ...

    Headlamp aiming adjustment
    LHD LHD : Description PREPARATION BEFORE ADJUSTING NOTE: • For details, refer to the regulations in your own country. • Perform aiming if the vehicle front body has been repaired and/or the headlamp assembly has been replaced. Before performing aiming adjustment, check the following. ...