Nissan Juke Service and Repair Manual : 4WD warning lamp blinks slowly

Description

4WD warning lamp blinks at approximately 2 seconds intervals while driving.

Diagnosis Procedure

1.CHECK TIRE

Check the following.

• Tire pressure
• Wear condition
• Front and rear tire size (There is no difference between front and rear tires.)

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace error-detected parts. And then, drive the vehicle at speed of 20 km/h (12 MPH) or more for 5 seconds or more. Improper size information is initialized accordingly.

2.TERMINAL INSPECTION

Check 4WD control unit harness connector for disconnection.

Is the inspection result normal? YES >> Replace 4WD control unit. Refer to DLN-91, "Removal and Installation".

NO >> Repair or replace the error-detected parts.

    4WD warning lamp blinks quickly
    Description While driving, 4WD warning lamp blinks 2 times in 1 second and it turns OFF after 1 minute. NOTE: • This symptom protects drivetrain parts when a heavy load is applied to the el ...

    Noise, vibration and harshness (NVH) troubleshooting
    NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, repair or replace these parts. ...

    Other materials:

    Door lock actuator
    Driver side : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES &g ...

    ESP off indicator lamp
    Component Function Check 1.CHECK ESP OFF INDICATOR LAMP FUNCTION (1) Check that ESP OFF indicator lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON. CAUTION: Never start engine. Is the inspection result normal? YES >> GO TO 2. NO >> ...

    Vehicle Dynamic Control (VDC) system
    The Vehicle Dynamic Control (VDC) system uses various sensors to monitor driver inputs and vehicle motion. Under certain driving conditions, the VDC system helps to perform the following functions. • Controls brake pressure to reduce wheel slip on one slipping drive wheel so power is transf ...