Nissan Juke Service and Repair Manual : Refrigerant pressure sensor
Exploded View
Refer to HA-39, "Exploded View". (HR16DE) Refer to HA-94, "Exploded View". (MR16DDT)
Removal and Installation
REMOVAL
Remove refrigerant pressure sensor.
Refer to HA-42, "REFRIGERANT PRESSURE SENSOR : Removal and Installation".
(HR16DE)
Refer to HA-96, "REFRIGERANT PRESSURE SENSOR : Removal and Installation".
(MR16DDT)
INSTALLATION
Install in the reverse order of removal.
Thermo control amplifier
Removal and Installation
REMOVAL
1. Remove evaporator.
• Refer to HA-55, "EVAPORATOR : Removal and Installation". (HR16DE)
• Refer to HA-115, "EVAPORATOR : Removal and Install ...
Blower fan resistor
Exploded View
1. A/C unit assembly
2. Fan control amp.*1
3. Blower fan resistor*2
4. Blower motor
5. Blower motor cover
• *1: Automatic air conditioner
• *2: Manual air conditioner
R ...
Other materials:
The oil pressure warning lamp does not turn on
Description
The oil pressure warning lamp stays off when the ignition switch is turned
ON.
Diagnosis Procedure
1.CHECK OIL PRESSURE WARNING LAMP
Perform auto active test. Refer to PCS-12, "Diagnosis Description" (with
I-KEY) or PCS-43, "Diagnosis
Description" (without I- ...
Wiring diagram
WARNING CHIME SYSTEM
Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
P1220 fuel pump control module (FPCM)
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
• Before performing the following procedure, con ...
