Nissan Juke Service and Repair Manual : Thermo control amplifier

Removal and Installation

REMOVAL

1. Remove evaporator.

• Refer to HA-55, "EVAPORATOR : Removal and Installation". (HR16DE) • Refer to HA-115, "EVAPORATOR : Removal and Installation". (MR16DDT)

2. Remove the thermo control amp. from evaporator.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
• Replace O-ring with new one. Then apply compressor oil to them when installing.

• When install the thermo control amp., set the same position before replacement.

• When remove the thermo control amp., never turn the bracket which is equipped the top of the thermo control amp.

• Check for the leakages when recharging refrigerant. Refer to HA-19, "Leak Test". (HR16DE) or HA-74, "Leak Test". (MR16DDT)

    A/C control
    Exploded View 1. Intake door cable 2. Air mix door cable 3. Mode door cable 4. A/C control 5. Intake door lever knob A. To intake door link B. To air mix door link C. To mode door link ...

    Refrigerant pressure sensor
    Exploded View Refer to HA-39, "Exploded View". (HR16DE) Refer to HA-94, "Exploded View". (MR16DDT) Removal and Installation REMOVAL Remove refrigerant pressure sensor. Refe ...

    Other materials:

    Wiring diagram
    ELECTRONICALLY CONTROLLED POWER STEERING SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    Diagnosis and repair workflow
    Gasoline engine models GASOLINE ENGINE MODELS : Work Flow OVERALL SEQUENCE DETAILED FLOW 1.PRELIMINARY INSPECTION Perform the preliminary inspection. Refer to CHG-17, "Inspection Procedure". Models with battery current sensor>>GO TO 2. Models without battery current sens ...

    Intake manifold
    Exploded View 1. EVAP canister purge volume control solenoid valve 2. Hose clamp 3. Vacuum hose 4. Intake manifold support 5. Gasket 6. Intake manifold 7. Electric throttle control actuator 8. Gasket A. To air cleaner B. To centralized under-floor piping C. To brake booster D. ...