Nissan Juke Service and Repair Manual : BCM

Removal and Installation

CAUTION:
Before replacing BCM, perform “READ CONFIGURATION� to save or print current vehicle specification.

Refer to BCS-80, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description".

REMOVAL (RHD MODELS)

1. Remove glove box assembly. Refer to IP-13, "Removal and Installation".

2. Remove harness clip.

3. Remove BCM mounting screws.

4. Remove BCM and disconnect the connectors.

5. Remove relays and relay mounting bracket from BCM.

REMOVAL (LHD MODELS)

1. Remove instrument lower panel. Refer to IP-13, "Removal and Installation".

2. Remove harness clip.

3. Remove BCM mounting screws.

4. Remove BCM and disconnect the connectors.

5. Remove relays and relay mounting bracket from BCM.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
• Be sure to perform “WRITE CONFIGURATION� when replacing BCM.

• Be sure to perform the system initialization (NATS) when replacing BCM. Refer to BCS-80, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Special Repair Requirement".

    Combination switch
    Exploded View 1. Combination switch 2. Combination switch connector Removal and Installation REMOVAL 1. Remove steering column cover. Refer to IP-13, "Removal and Installation". 2 ...

    Other materials:

    P0237, P0238 TC boost sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    Brake piping
    Front : Exploded View WITHOUT ESP 1. Brake tube 2. ABS actuator and electric unit (control unit) 3. Connector 4. Connector bracket 5. Master cylinder assembly 6. Brake booster 7. Lock plate 8. Brake hose 9. Union bolt 10. Copper washer A. To rear brake tube : N·m (kg-m, ft-lb) ...

    The oil pressure warning lamp does not turn on
    Description The oil pressure warning lamp stays off when the ignition switch is turned ON. Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform auto active test. Refer to PCS-12, "Diagnosis Description" (with I-KEY) or PCS-43, "Diagnosis Description" (without I- ...