Nissan Juke Service and Repair Manual : Operation inspection

Work Procedure

The purpose of the operational check is to check that the individual system operates normally.

Check condition : Engine running at normal operating temperature.

1.CHECK BLOWER MOTOR

1. Operate fan control dial.

2. Check that fan speed changes. Check operation for all fan speeds.

Is the inspection result normal? YES >> GO TO 2.

NO >> GO TO 8.

2.CHECK DISCHARGE AIR

1. Operate fan control dial to set the fan speed to maximum speed.

2. Operate MODE dial to each position.

3. Check that air outlets change according to each indicated air outlet by placing a hand in front of the air outlets. Refer to VTL-5, "System Description".

Is the inspection result normal? YES >> GO TO 3.

NO >> GO TO 8.

3.CHECK INTAKE AIR

1. Operate intake lever to each position.

2. Listen to intake sound and confirm air inlets change.

Is the inspection result normal? YES >> GO TO 4.

NO >> GO TO 8.

4.CHECK COMPRESSOR

1. Press A/C switch. The A/C switch indicator is turns ON.

2. Check visually and by sound that the compressor operates.

3. Press A/C switch again. The A/C switch indicator is turns OFF.

4. Check that compressor stops.

Is the inspection result normal? YES >> GO TO 5.

NO >> GO TO 8.

5.CHECK DISCHARGE AIR TEMPERATURE

1. Operate temperature control dial.

2. Check that discharge air temperature changes.

Is the inspection result normal? YES >> GO TO 6.

NO >> GO TO 8.

6.CHECK TEMPERATURE DECREASE

1. Operate compressor.

2. Turn temperature control dial to full cold position.

3. Check that cool air blows from the air outlets.

Is the inspection result normal? YES >> GO TO 7.

NO >> GO TO 8.

7.CHECK TEMPERATURE INCREASE

1. Turn temperature control dial to full hot position.

2. Check that warm air blows from air outlets.

Is the inspection result normal? YES >> INSPECTION END

NO >> GO TO 8.

8.CHECK SELF-DIAGNOSIS WITH CONSULT-III

1. Perform self-diagnosis with CONSULT-III.

2. Check that any DTC is detected.

Is any DTC detected? YES >> Perform trouble diagnosis for the detected DTC.

NO >> Refer to HAC-297, "Symptom Table" and perform the appropriate diagnosis.

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Interview the symptom to the customer. >> GO TO 2. 2.SYMPTOM CHECK Check the symptom from the customer's informa ...

    Other materials:

    Audio unit
    Removal and Installation REMOVAL 1. Remove cluster lid C. Refer to IP-12, "Exploded View". 2. Remove audio unit screws. 3. Disconnect audio unit connectors to remove audio unit and brackets as a single unit. 4. Remove brackets screws to remove audio unit. INSTALLATION 1. Install ...

    Fog light switch (if so equipped)
    To turn the fog lights on, turn the headlight switch to the position, then turn the switch to the position. To turn them off, turn the switch to the OFF position. The headlights must be on for the fog lights to operate. When the headlight switch is in the AUTO position, turning the fog lig ...

    Road test
    Description DESCRIPTION • The purpose of the test is to determine overall performance of CVT and analyze causes of problems. • The road test consists of the following three parts: 1. “Check Before Engine Is Started” TM-190. 2. “Check at Idle” TM-191. 3. “Cruise Test” TM-192. ...