Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B257B, B257C ambient sensor
- Power supply and ground circuit
- A/C switch
- Blower fan on signal
- Thermo control amplifier
- A/C indicator
- Blower motor
- Magnet clutch
- PTC heater
Operation inspection
Work Procedure
The purpose of the operational check is to check that the individual system
operates normally.
Check condition : Engine running at normal operating temperature.
1.CHECK BLOWER MOTO ...
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication system for real time
application. It is an on-vehicle
multiplex communication system with high data communication speed and exce ...
Other materials:
Precaution for Seat Belt Service
CAUTION:
• Before removing the front seat belt pre-tensioner assembly, turn the ignition
switch off, disconnect
battery negative terminal and wait at least 3 minutes.
• Do not use electrical test equipment for front seat belt pre-tensioner
connector.
• After replacing or reinstalling f ...
Back door lock
Exploded View
1. Back door lock assembly 2. TORX bolt 3. Back door striker
: Do not reuse
: N·m (kg-m, ft-lb)
: Body grease
Door lock
DOOR LOCK : Removal and Installation
REMOVAL
1. Remove the back door lower finisher. Refer to INT-35, "BACK DOOR LOWER
FINISHER : Removal and
Insta ...
P1643 thermoplunger control unit
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect thermoplunger control unit harness connector.
3. Check the voltage between thermoplunger control unit harness connector and
ground.
Is the ...
