Nissan Juke Service and Repair Manual : U1010 control unit (can)

Description

Initial diagnosis of A/C auto amp.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM SELF-DIAGNOSIS

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of “PTC HEATER” using CONSULT-.III 3. Check DTC.

Is DTC detected? YES >> Refer to HAC-276, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.REPLACE PTC HEATER CONTROL UNIT

Replace PTC heater control unit.

>> INSPECTION END

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-vehicle multiplex communication system with high data communication speed and exce ...

    B257B, B257C ambient sensor
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 275, "DTC Logic". • If DTC is disp ...

    Other materials:

    Intelligent Around View Monitor system limitations
    WARNING Listed below are the vital engineering system limitations for the Intelligent Around View Monitor. Failure to operate your vehicle in strict accordance with these system limitations could blind the driver to surrounding hazards, which could result in ser ...

    P2101 electric throttle control function
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P2101 is displayed with DTC P2100, first perform the trouble diagnosis for DTC P2100. Refer to EC-376, "DTC Logic". • If DTC P2101 is displayed with DTC P2119, first perform the trouble diagnosis for DTC P2119. Refer to EC-383, &qu ...

    Getting started
    The following procedures will help you get started using the Bluetooth® Hands-Free Phone System with NISSAN Voice Recognition. For additional command options, refer to “List of voice commands” . Choosing a language You can interact with the Bluetooth® Hands- Free Phone System using Engli ...