The following procedures will help you get started using the Bluetooth® Hands-Free Phone System with NISSAN Voice Recognition. For additional command options, refer to “List of voice commands” .

Choosing a language

You can interact with the Bluetooth® Hands- Free Phone System using English, Spanish or French.

To change the language, perform the following.

1. Push and hold the button for
more than 5 seconds.

2. The system announces: “Push the PHONE SEND ( ) button for the hands-free phone system
to enter the speaker adaptation mode or push the PHONE END (
) button to select a different language.” 3. Push the button.

For information on speaker adaptation, see “Speaker Adaptation (SA) mode” .

4. The system announces the current language and gives you the option to change the language to Spanish (in Spanish) or French (in French). To select the current language, press the button. To select
a different language, tilt the tuning switch ( or ) up or down.

NOTE:

You must press the

button
within 5 seconds to change the language.

5. If you decide not to change the language, do not push either button. After 5 seconds, the VR session will end, and the language will not be changed.

Connecting proce

NOTE:

The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled.

1. Push the button on the steering
wheel. The system announces the available commands.

2. Say: “Connect Phone” A . The system acknowledges the command and announces the next set of available commands.

3. Say: “Add phone”B . The system acknowledges the command and asks you to initiate pairing from the phone handset C .

The connecting procedure of the cellular phone varies according to each cellular phone. See the cellular phone Owner’s Manual for details. You can also visit www.

nissanusa.com/bluetooth for instructions on connecting NISSAN recommended cellular phones.

When prompted for a Passkey code, enter “1234” from the handset. The Passkey code “1234” has been assigned by NISSAN and cannot be changed.

4. The system asks you to say a name for the phoneD .

If the name is too long or too short, the system tells you, then prompts you for a name again.

Also, if more than one phone is connected and the name sounds too much like a name already used, the system tells you, then prompts you for a name again.

Making a call by entering a phone number

1. Push the button on steering wheel.
A tone will sound.

2. Say: “Call” A . The system acknowledges the command and announces the next set of available commands.

3. Say: “Phone Number” B . The system acknowledges the command and announces the next set of available commands.

Say: “Special Dialing” to dial more than 10 digits or any special characters.

4. Say the number you wish to call starting with the area code in single digit format. If the system has trouble recognizing the correct phone number, try entering the number in the following groups: 3-digit area code, 3- digit prefix and the last 4-digits. For example, 555-121-3354 can be said as “five five five” as the 1st group, then “one two one” as the 2nd group, and “three three five four” as the 3rd group. For dialing more than 10 digits or any special characters, say “Special Dialing”.

See “How to say numbers”  for more information.

5. When you have finished speaking the phone number, the system repeats it back and announces the available commands.

6. Say: “Dial” C . The system acknowledges the command and makes the call.

For additional command options, see “List of voice commands” .

Receiving a call When you hear the ring tone, push the button on the steering wheel.

Once the call has ended, push the  button on the steering wheel.

NOTE:

If you do not wish to take the call when you hear the ring tone, push the

button on the steering wheel
to reject the call.