Nissan Juke Service and Repair Manual : Unbalance steering wheel turning force and return between right and left

Nissan Juke Service and Repair Manual / Steering Control System / Symptom diagnosis / Unbalance steering wheel turning force and return between right and left

Description

Unbalance steering wheel turning force and return between right and left.

Diagnosis Procedure

1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP

Check the EPS warning lamp while engine is running.

Does the EPS warning lamp turn OFF? YES >> GO TO 2.

NO >> Refer to STC-28, "Diagnosis Procedure".

2.CHECK WHEEL ALIGNMENT

1. Check the wheel alignment. Refer to FSU-7, "Inspection".

2. Perform “EPS” self-diagnosis.

Is the inspection result normal? YES >> GO TO 3.

NO >> Adjustment of wheel alignment. Refer to FSU-7, "Inspection".

3.CHECK EPS CONTROL UNIT SIGNAL

1. Start the engine.With CONSULT-III


1. Start the engine.

CAUTION:
Never drive the vehicle.

2. Turn steering wheel from full left stop to full right stop.

3. Select “DATA MONITOR” of “EPS” and select “TORQUE SENSOR”.

4. Perform the torque sensor inspection.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 5.

NO >> GO TO 4.

4.CHECK EPS MOTOR

Perform the trouble diagnosis of EPS motor. Refer to STC-22, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the specific malfunctioning part.

5.CHECK STEERING WHEEL TURNING FORCE

Check the steering wheel turning force. Refer to ST-5, "Inspection".

Is the inspection result normal? YES >> INSPECTION END

NO >> Check the steering wheel turning force for mechanical malfunction. Refer to ST-21, "Inspection"

    Steering wheel turning force is heavy or light
    Description Steering wheel turning force is heavy or light. Diagnosis Procedure 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check that the EPS warning lamp turns ON when ignition switch turns ...

    Unbalance steering wheel turning force (torque variation)
    Description Unbalance steering wheel turning force (torque variation). Diagnosis Procedure 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check the EPS warning lamp while engine is running. D ...

    Other materials:

    Vehicle speed sensing auto lock operation does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT” setting in “WORK SUPPORT”. Refer to DLK-371, "DO ...

    B26F8 BCM
    DTC Logic DTC DETECTION LOGIC NOTE: DTC B26F8 can be detected even though the related circuit is not used in this vehicle. DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON and wait 1 second. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” u ...

    Inspection
    INSPECTION AFTER INSTALLATION • Check accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released. • Check accelerator pedal securely returns to the fully released position. • For the electrical inspection of accelerator pedal position sensor. Refe ...