Nissan Juke Service and Repair Manual : P181D engine torque signal

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

1. Start the engine and drive at 20 km/h (12 MPH) or more.With CONSULT-III


1. Start the engine and drive at 20 km/h (12 MPH) or more.

2. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is DTC “P181D” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-54, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM ECM SELF-DIAGNOSIS

Perform self-diagnosis for “ENGINE”.With CONSULT-III


Perform self-diagnosis for “ENGINE”.

Is any DTCs detected? YES >> Check the DTCs. Refer to EC-108, "DTC Index".

NO >> GO TO 2.

2.ERASE SELF-DIAGNOSTIC RESULT

1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.With CONSULT-III


1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.

2. Turn the ignition switch OFF.

3. Start the engine and drive vehicle for a while.

4. Check that malfunction indicator lamp (MIL) turns OFF.

Does malfunction indicator lamp (MIL) turn OFF? YES >> GO TO 3.

NO >> Refer to EC-436, "Diagnosis Procedure".

3.CHECK TERMINALS AND HARNESS CONNECTORS

Check 4WD control module pin terminals for damage or loose connection with harness connector.

Is inspection result normal? YES >> After turning the ignition switch OFF, perform DTC confirmation procedure again. When DTC “P181D” is detected, Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    P181B incomplete selfshut
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    P181E steering angle sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    Other materials:

    Diagnosis system (audio unit)
    Models with usb connection function MODELS WITH USB CONNECTION FUNCTION : On Board Diagnosis Function Self-diagnosis mode can check the following items. METHOD OF STARTING 1. Start the engine. 2. Turn OFF audio. 3. While pressing the “SET UP” switch, turn the MENU dial counterclockwise ...

    Accelerator pedal released position learning
    Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position sensor ...

    Fuel injector
    Component Function Check 1.INSPECTION START Turn ignition switch to START. Is any cylinder ignited? YES >> GO TO 2. NO >> Go to EC-778, "Diagnosis Procedure". 2.CHECK FUEL INJECTOR FUNCTION With CONSULT-III 1. Start engine. 2. Perform “POWER BALANCE” in “AC ...