Nissan Juke Service and Repair Manual : P181E steering angle sensor

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

1. Turn the ignition switch OFF to ON.With CONSULT-III


1. Turn the ignition switch OFF to ON.

2. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is DTC “P181E” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-50, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS

Perform self-diagnosis for “ABS”.With CONSULT-III


Perform self-diagnosis for “ABS”.

Is DTC “C1143” detected? YES >> Proceed to diagnosis procedure. Refer to BRC-189, "Diagnosis Procedure".

NO >> GO TO 2.

2.CHECK CAN COMMUNICATION LINE

Check communication line. Refer to LAN-44, "Diagnosis Procedure".

Is inspection result normal? YES >> Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    P181D engine torque signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    P181F incomplete calibration
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    Other materials:

    Diagnosis system (BCM)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the ...

    ASCD main switch
    Component Function Check 1.CHECK ASCD MAIN SWITCH FUNCTION With CONSULT-III 1. Turn ignition switch ON. 2. Select “MAIN SW” in “DATA MONITOR” mode of “ENGINE” using CONSULT-III. 3. Check “MAIN SW” indication as per the following condition. Without CONSULT-III 1. Turn ignitio ...

    Oil filter
    Exploded View 1. O-ring 2. Oil filter bracket 3. Oil pressure switch 4. Oil filter 5. O-ring 6. Connecting bolt A. To oil cooler : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVAL 1. Using an oil filter wrench [SST:KV113C0010 (Mot.1329 ...