Nissan Juke Service and Repair Manual : Service data and specifications (SDS)

Wheel Bearing

Drive Shaft


Drive Shaft

*: For measuring position, refer to FAX-81, "WHEEL SIDE : Disassembly and


*: For measuring position, refer to FAX-81, "WHEEL SIDE : Disassembly and Assembly" (Wheel side), FAX- 84, "TRANSAXLE SIDE : Disassembly and Assembly" (Transaxle side).

    Front drive shaft
    Exploded View LEFT SIDE 1. Circular clip 2. Dust shield 3. Housing assembly 4. Boot band 5. Boot 6. Damper band 7. Dynamic damper 8. Circular clip 9. Joint sub-assembly : Wheel side ...

    Other materials:

    Cooler pipe and hose
    Exploded View 1. A/C unit assembly 2. O-ring 3. High-pressure pipe 4. O-ring 5. Low-pressure flexible hose 6. High-pressure flexible hose 7. O-ring 8. Condenser 9. Compressor : Do not reuse : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) High-pressure flexible hose : Removal and Instal ...

    P0117, P0118 ECT SENSOR
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...

    System
    4WD system : System Diagram INPUT/OUTPUT SIGNAL It transmits/receives each signal from the following 4WD control module via CAN communication line. 4WD system : System Description • 4WD mode is selectable among 2WD, 4WD-V, and 4WD by operating the 4WD mode switch. • When judging d ...