Service data and specifications (SDS)

Wheel Bearing Drive Shaft *: For measuring position, refer to FAX-81, "WHEEL SIDE : Disassembly and Assembly" (Wheel side), FAX- 84, "TRANSAXLE SIDE : Disassembly and Assembly& ...

Preparation

Commercial Service Tools ...

Other materials:

P0520 EOP sensor
DTC Logic DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Turn ignitio ...

Refilling
1. Remove filler plug (1) and gasket. Then fill oil up to mounting hole for the filler plug. : Vehicle front Oil and viscosity : Refer to MA-13, "Fluids and Lubricants". Oil capacity : Refer to DLN-117, "General Specifications". CAUTION: Carefully fill the oil. (Fill up ...

B1118, B1119 satellite sensor LH
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...