Nissan Juke Service and Repair Manual : Periodic maintenance
REAR WHEEL HUB
Inspection
COMPONENT PART
Check the mounting conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal.
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)
Check the following items, and replace the part it necessary.
• Move wheel hub assembly in the axial direction by hand. Check there is no looseness of wheel bearing.
Axial end play : Refer to RAX-7, "Wheel Bearing".
• Rotate wheel hub assembly and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub assembly.
Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or
replace these parts.
×: Applicable ...
Removal and installation
REAR WHEEL HUB
Exploded View
1. Rear suspension beam
2. Rear brake assembly
3. Hub bolt
4. Wheel hub assembly (Bearing-integrated
type)
5. Disc rotor
6. Plug
: Always replace after every ...
Other materials:
NISSAN Vehicle Immobilizer System
The NISSAN Vehicle Immobilizer System is a sophisticated anti-theft security feature designed specifically for your Nissan Leaf. It ensures that the EV power switch cannot be shifted into the READY to drive position unless the vehicle detects an authentic, registered Intelligent Key.
...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always us ...
Basic inspection
Diagnosis and repair work flow
Work Flow
DETAILED FLOW
1.INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an
interview utilizing BRC-34, "Diagnostic
Work Sheet" and reproduce the symptom as well as fully understand it. Ask
customer a ...
