Symptom diagnosis

COMBINATION SWITCH SYSTEM SYMPTOMS Symptom Table 1. Perform “Data Monitor” of CONSULT-III to check for any malfunctioning item. 2. Check the malfunction combinations. 3. Identify the malfu ...

BCM

Removal and Installation CAUTION: Before replacing BCM, perform “READ CONFIGURATION” to save or print current vehicle specification. Refer to BCS-80, "ADDITIONAL SERVICE WHEN REPLACING C ...

Other materials:

P0132 A/F sensor 1
DTC Logic DTC DETECTION LOGIC To judge the malfunction, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal is not inordinately high. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ig ...

B1182 lap Pre-tensioner LH
DTC Logic DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSTIC RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp status. Refe ...

Component parts
Component Parts Location 1. A/C auto amp Refer to HAC-12, "Component Parts Location" 2. ECM Refer to EC-25, "ENGINE CONTROL SYSTEM : Component Parts Location" 3. TCM Refer to TM-314, "CVT CONTROL SYSTEM : Component Parts Location" 4. EPS control unit Refer ...