Nissan Juke Service and Repair Manual : Basic inspection

Radiator

Inspection

Check radiator for mud or clogging. If necessary, clean radiator as follows.

CAUTION:
• Be careful not to bend or damage the radiator fins.

• When radiator is cleaned without removal, remove all surrounding parts such as radiator fan, radiator shroud and horns. Then tape the harness and connectors to prevent water from entering.

1. Apply water by hose to the back side of the radiator core vertically downwards.

2. Apply water again to all radiator core surface once per minute.

3. Stop washing if any stains no longer flow out from the radiator.

4. Blow air into the back side of radiator core vertically downwards.

• Use compressed air lower than 490 kPa (4.9 bar 5 kg/cm2, 71psi) and keep distance more than 30 cm (11.8 in).

5. Blow air again into all the radiator core surface once per minute until no water sprays out.

    Cooling system
    Cooling Circuit 1. Radiator 2. Reservoir tank 3. Heating elements (Thermo plungers) 4. Heater core 5. Exhaust gas cooler 6. Thermostat 7. Water pump 8. Water-oil heat exchanger 9. Ble ...

    Symptom diagnosis
    OVERHEATING CAUSE ANALYSIS Troubleshooting Chart ...

    Other materials:

    Ecu diagnosis information
    AUDIO UNIT Reference Value TERMINAL LAYOUT PHYSICAL VALUES • *1: Models with USB connection function • *2: Models without USB connection function ...

    How to quick charge
    Quick charging allows you to replenish your Nissan Leaf battery in a significantly shorter period by utilizing public high-capacity charging stations. Depending on your specific vehicle configuration, these stations can deliver power up to 50 kW for 40 kWh battery models, or up to 100 kW for 60 kWh ...

    P0715 input speed sensor A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repai ...