Nissan Juke Service and Repair Manual : P1820 engine speed signal

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

1. Start the engine and drive at 20 km/h (12 MPH) or more.With CONSULT-III


1. Start the engine and drive at 20 km/h (12 MPH) or more.

2. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is DTC “P1820” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-52, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM ECM SELF-DIAGNOSIS

Perform self-diagnosis for “ENGINE”.With CONSULT-III


Perform self-diagnosis for “ENGINE”.

Is any DTCs detected? YES >> Check the DTCs. Refer to EC-108, "DTC Index".

NO >> GO TO 2.

2.ERASE SELF-DIAGNOSTIC RESULT

1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.With CONSULT-III


1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.

2. Turn the ignition switch OFF.

3. Start the engine and drive vehicle for a while.

4. Check that malfunction indicator lamp (MIL) turns OFF.

Does malfunction indicator lamp (MIL) turn OFF? YES >> GO TO 3.

NO >> Refer to EC-436, "Diagnosis Procedure".

3.CHECK TERMINALS AND HARNESS CONNECTORS

Check 4WD control module pin terminals for damage or loose connection with harness connector.

Is inspection result normal? YES >> After turning the ignition switch OFF, perform DTC confirmation procedure again. When DTC “P1820” is detected, Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    P181F incomplete calibration
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    P1829 accelerator pedal position sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    Other materials:

    Foreword
    This manual contains maintenance and repair procedures for the NISSAN JUKE, model F15 series. In order to assure your safety and the efficient functioning of the vehicle, this manual should be read thoroughly. It is especially important that the PRECAUTIONS in the GI section be completely unde ...

    Supplemental air bag warning labels
    Supplemental front-impact air bag system warning labels Supplemental air bag warning light The supplemental air bag warning light, identified by the icon located on the instrument panel, serves as a comprehensiv ...

    Unit removal and installation
    Transaxle assembly Exploded View 1. Transaxle assembly : Refer to "INSTALLATION" in TM-30, "Removal and Installation" for the locations and tightening torque. Removal and Installation CAUTION: Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the ...