Nissan Juke Service and Repair Manual : P1830 ABS operation signal

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.DTC REPRODUCTION PROCEDURE

1. Start the engine and drive at 30 km/h (19 MPH) or more.With CONSULT-III


1. Start the engine and drive at 30 km/h (19 MPH) or more.

2. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is DTC “P1830” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-62, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS

Perform self-diagnosis for “ABS”.With CONSULT-III


Perform self-diagnosis for “ABS”.

Is any DTCs detected? YES >> Check the DTCs. Refer to BRC-142, "DTC Index".

NO >> GO TO 2.

2.ERASE SELF-DIAGNOSTIC RESULT

1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.With CONSULT-III


1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.

2. Start the engine and drive vehicle at 30 km/h (19 MPH) or more.

3. Check that ABS warning lamp turns OFF.

Does ABS warning lamp turn OFF? YES >> GO TO 3.

NO >> Refer to BRC-212, "Diagnosis Procedure".

3.CHECK TERMINALS AND HARNESS CONNECTORS

Check 4WD control module pin terminals for damage or loose connection with harness connector.

Is inspection result normal? YES >> After turning the ignition switch OFF, perform DTC confirmation procedure again. When DTC “P1830” is detected, Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    P182F coupling temperature sensor left
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    P1831 VDC operation signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DTC REPRODUCTION PROCEDURE With CONSULT-III 1. Start the engine and drive at 30 km/h (19 MPH) or more. 2. Perform self-diagnosis for ...

    Other materials:

    Rapid air pressure loss
    Rapid air pressure loss or a “blow-out” can occur if the tire is punctured or is damaged due to hitting a curb or pothole. Rapid air pressure loss can also be caused by driving on underinflated tires. Rapid air pressure loss can affect the handling and stability of the vehicle, especially ...

    Front wiper motor hi circuit
    Component Function Check 1.CHECK FRONT WIPER HI OPERATION CONSULT-III ACTIVE TEST 1. Select “FRONT WIPER” of IPDM E/R active test item. 2. With operating the test item, check front wiper operation. Hi : Front wiper (HI) operation Off : Stop the front wiper Is front wiper (HI) operation no ...

    P2138 APP sensor
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P2138 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to EC-686, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ...